Honda 2005-2008 RX500 FA Service Manual page 241

'61HN252' by American Honda Motor Co. - Page 241 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
INSTALLATION
Apply locking agent to the stopper arm pivot bolt
threads.
Install the return spring as shown.
Install the washer, stopper arm and pivot bolt, and
tighten the bolt.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Insert the gearshift spindle into the crankcase.
Install the setting plate and tighten the bolt.
Apply oil to the shift drum guide grooves.
Lower the stopper arm and installing the shift drum
by aligning the index lug of the shift drum with the
index line on the gearshift spindle.
Turn the shift drum clockwise and set it in neutral
position so that its groove position is lengthwise as
shown.
Install the shift forks into the gear shifter grooves
and shift drum guide grooves with the marks facing
out.
Coat the shift fork shaft with oil and insert it into the
shift forks and crankcase.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
SUB-TRANSMISSION/GEARSHIFT LINKAGE
PIVOT BOLT
STOPPER ARM
GEARSHIFT SPINDLE
BOLT
SHIFT DRUM
INDEX LINE
MARK
SHIFT FORK SHAFT
RETURN SPRING
WASHER
SETTING PLATE
INDEX LUG
SHIFT FORKS
GROOVE
12-11
3/9/2008 10:58 PM