Honda 2005-2008 RX500 FA Service Manual page 207

'61HN252' by American Honda Motor Co. - Page 207 of 540
[2005-2008] [TRX500 FA/FGA]
CENTRIFUGAL CLUTCH
Be careful not to
crankshaft threads.
1 of 1
Coat a new O-ring with oil and install it onto the oil
feed pipe setting cap.
Install and tighten the setting cap.
TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)
Install the left engine side cover stay by aligning the
locating tab with the groove in the rear crankcase
cover, and tighten the two bolts.
Install the left engine side cover and collars then
tighten the bolt and socket bolts.
Install the following:
oil tank (page 4-8)
gearshift linkage (page 7-10)
inner fenders (page 2-9)
front mud guards (page 2-8)
Adjust the tie-rod length of the gearshift lever link-
age (page 12-18).
DISASSEMBLY
Remove the front crankcase cover (page 10-2).
Unstake the centrifugal clutch lock nut.
damage the
Install the special tools by aligning the pins with the
grooves in the drive plate.
Hold the drive plate and loosen the lock nut
TOOLS:
Clutch holder
clutch holder plate
holder plate pin
Remove the lock nut and washer.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
STAY
LEFT ENGINE
SIDE COVER
CLUTCH HOLDER
07ZMB-HN20000 or
07ZMB-HN2A100
(U.S.A. only)
07ZMB-HN20100
07ZMB-HN20200
CENTRIFUGAL CLUTCH
O-RING
SETTING CAP
COLLARS
BOLTS
SOCKET BOLTS
Unstake
WASHER
LOCK NUT
10-9
3/9/2008 10:54 PM