Honda 2005-2008 RX500 FA Service Manual page 317

'61HN252' by American Honda Motor Co. - Page 317 of 540
[2005-2008] [TRX500 FA/FGA]
Refer to torque
wrench reading
information on page
1 of 1
Tighten the right pivot lock nut using the special
tool, while holding the pivot bolt.
TOOL:
Lock nut wrench
TORQUE: Actual: 112 N·m (11.4 kgf·m, 82 lbf·ft)
Indicated: 102 N·m (10.4 kgf·m, 75 lbf·ft)
"Service
15-3
Information".
Install the left and right pivot caps securely.
Install the universal joint boot band and screw so
that the screw is positioned top and facing left side.
Tighten the band screw.
Route the breather hoses properly
secure them with the clamps.
Install the final drive assembly
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
07908-4690003
(page 1-22) and
(page 18-21).
REAR WHEEL/SUSPENSION
LOCK NUT
LOCK NUT WRENCH
BOOT BAND SCREW
CLAMPS
BREATHER HOSES
PIVOT CAP
15-13
3/9/2008 11:09 PM