Honda 2005-2008 RX500 FA Service Manual page 183

'61HN252' by American Honda Motor Co. - Page 183 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
If the ECT sensor was removed, apply sealant to the
ECT sensor threads. Do not apply sealant to the sen-
sor head.
Install and tighten the ECT sensor.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
If the carburetor insulator was removed, install it,
aligning its groove with the lug on the cylinder
head.
Install and tighten the spark plug.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Connect the ECT sensor connector.
Install the mounting rubbers on the upper engine
hanger bushing with the large I.D. side facing in.
Install the upper engine hanger bracket and bolts.
Tighten the engine side hanger bolts.
TORQUE: 32 N·m (3.3 kgf·m, 24 lbf·ft)
Tighten the upper engine hanger nut.
TORQUE: 54 N·m (5.5 kgf·m, 40 lbf·ft)
Connect the bypass hoses to the cylinder head.
Coat the cam followers with oil and install them into
the cylinder head.
Install the following:
water pump (page 6-12)
cylinder head cover (page 8-22)
thermostat (page 6-10)
carburetor (page 5-18)
exhaust pipe (page 2-14)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
CYLINDER HEAD/VALVE/CAMSHAFT
HANGER
BRACKET
BYPASS
HOSES
CONNECTOR
ECT SENSOR
GROOVE AND LUG
MOUNTING RUBBERS
BOLT/
NUT
BOLTS
CAM FOLLOWERS
8-21
3/9/2008 10:51 PM