Honda 2005-2008 RX500 FA Service Manual page 401

'61HN252' by American Honda Motor Co. - Page 401 of 540
[2005-2008] [TRX500 FA/FGA]
Refer to torque
wrench reading
information on
Be careful not to
damage the threads
1 of 1
PINION GEAR INSTALLATION
Drive the pinion gear assembly into the gear case
using the special tool.
TOOL:
Oil seal driver
· Keep the driver centered with the bearing outer
race during installation.
Install a new lock nut and tighten it using the special
tool.
page
TOOL:
"Service
18-3
Lock nut wrench, 30 x 64 mm 07916-MB00002
Information".
TORQUE: Actual:
Indicated: 89 N·m (9.1 kgf·m, 66 lbf·ft)
Stake the lock nut into the case groove.
of the case.
Apply grease to a new oil seal lips and install it into
the gear case until it is fully seated, using the special
tools.
TOOLS:
Driver
Driver attachment
Make sure that the stopper ring is installed in the
pinion gear shaft groove.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
07965-KE80200
98 N·m (10.0 kgf·m, 72 lbf·ft)
07749-0010000
07LAD-PW50500
REAR DRIVING MECHANISM
OIL SEAL DRIVER
LOCK NUT
OIL SEAL
PINION GEAR
ASSEMBLY
Stake
STOPPER RING
18-19
3/9/2008 11:17 PM