Honda 2005-2008 RX500 FA Service Manual page 296

'61HN252' by American Honda Motor Co. - Page 296 of 540
[2005-2008] [TRX500 FA/FGA]
FRONT WHEEL/SUSPENSION/STEERING
14-28
1 of 1
Turn the inner race of the steering shaft bearing
with your finger. The bearing should turn smoothly
and quietly. Also check that the bearing outer race
fits tightly in the frame.
BEARING REPLACEMENT
Remove the upper and lower dust seals.
Remove the snap ring.
Drive the steering shaft bearing out of the frame.
Drive in a new bearing squarely with the marked
side facing up until it is fully seated.
TOOLS:
Driver
Attachment, 42 x 47 mm
Pilot, 22 mm
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
BEARING
07749-0010000
07746-0010300
07746-0041000
PILOT
DUST SEALS
SNAP RING
DRIVER
ATTACHMENT
3/9/2008 11:05 PM