Crankcase Separation - Honda 2005-2008 RX500 FA Service Manual

'61HN252' by American Honda Motor Co. - Page 258 of 540
[2005-2008] [TRX500 FA/FGA]
CRANKSHAFT/AUTOMATIC TRANSMISSION

CRANKCASE SEPARATION

13-8
1 of 1
Remove the following:
engine (page 7-4)
cylinder head and camshaft (page 8-8)
cylinder and piston (page 9-5)
centrifugal clutch (page 10-9)
flywheel and starter clutch (page 11-12)
sub-transmission and shift linkage (page 12-12)
angle sensor (page 24-41)
angle sensor joint
two bolts and oil separate plate
sprocket bolt
oil pump driven sprocket and drive chain
cam chain
pivot bolt and cam chain tensioner
washer and collar
Temporarily install the clutch drum onto the crank-
shaft and the gear holder as shown. Loosen the four
driven gear socket bolts and remove them.
TOOL:
Gear holder, 2.5 07724-0010100 or
07724-001A100
(U.S.A. only)
Remove the clutch drum and the primary driven
gear from the automatic transmission unit.
Remove the dowel pin.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
ANGLE SENSOR JOINT
CAM CHAIN
DRIVE CHAIN
BOLTS
OIL SEPARATE PLATE
TENSIONER
BOLT
GEAR HOLDER
CLUTCH DRUM BOLTS
SPROCKET
WASHER/COLLAR
DOWEL PIN
DRIVEN GEAR
3/9/2008 11:00 PM