Honda 2005-2008 RX500 FA Service Manual page 267

'61HN252' by American Honda Motor Co. - Page 267 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
Install the following:
pivot collar (into the tensioner pivot)
cam chain tensioner with bolt and washer
(between the tensioner and crankcase)
cam chain
oil pump drive chain and driven sprocket (with
the rolled edge of the sprocket facing to the
crankcase, and by aligning the flats of the
sprocket and pump shaft)
driven sprocket bolt (apply locking agent to the
threads)
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
oil separate plate with two bolts
new oil seal (do not apply oil)
angle sensor joint
Install the removed parts:
angle sensor (page 24-41)
centrifugal clutch (page 10-12)
sub-transmission and shift linkage (page 12-12)
flywheel and starter clutch (page 11-12)
cylinder and piston (page 9-9)
cylinder head and camshaft (page 8-17)
oil tank (page 4-8)
engine (page 7-8)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
CRANKSHAFT/AUTOMATIC TRANSMISSION
TENSIONER
Align
SPROCKET
CAM CHAIN
BOLTS
OIL SEPARATE PLATE
OIL SEAL
WASHER/COLLAR
BOLT
DRIVE CHAIN
BOLT
ANGLE SENSOR JOINT
13-17
3/9/2008 11:01 PM