Honda 2005-2008 RX500 FA Service Manual page 159

'61HN252' by American Honda Motor Co. - Page 159 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
Install the mounting rubbers on the upper hanger
bushing with the large I.D. side facing in.
Install the upper engine hanger bracket and bolts.
After installing all the mounting fasteners and seat
them, tighten the fasteners in order as follows.
Tighten the left and right lower engine hanger nuts.
TORQUE: 54 N·m (5.5 kgf·m, 40 lbf·ft)
Tighten the left lower hanger bracket bolts.
TORQUE: 32 N·m (3.3 kgf·m, 24 lbf·ft)
Tighten the engine side upper hanger bolts.
TORQUE: 32 N·m (3.3 kgf·m, 24 lbf·ft)
Tighten the frame side upper hanger bolt.
TORQUE: 54 N·m (5.5 kgf·m, 40 lbf·ft)
Install the universal joint boot onto the engine.
Install the boot band and tighten the screw securely.
Install the engine oil temperature (EOT) sensor with
a new sealing washer and tighten it.
TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)
Connect the EOT sensor connector.
Coat new O-rings with oil and install them onto the
oil pipes.
Install the oil pipes into the oil tank and tighten the
bolts securely.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
ENGINE REMOVAL/INSTALLATION
BRACKET
MOUNTING RUBBERS
UNIVERSAL JOINT BOOT BAND
EOT SENSOR
OIL PIPES
BOLT/NUT
BOLTS
SCREW
SEALING WASHER
CONNECTOR
O-RING
7-9
3/9/2008 10:48 PM