Honda 2005-2008 RX500 FA Service Manual page 302

'61HN252' by American Honda Motor Co. - Page 302 of 540
[2005-2008] [TRX500 FA/FGA]
FRONT WHEEL/SUSPENSION/STEERING
Press in the bearing
with the marking
side facing up.
14-34
1 of 1
Apply grease to the needle rollers of a new bearing.
Carefully press the needle bearing in the lower pivot
until the depth from the lower pivot outer surface is
5.4--5.5 mm (0.21--0.22 in), using the special tools.
TOOLS:
Driver
Attachment, 22 x 24 mm
Pilot, 16 mm
Apply grease to the new dust seal lips and install
them into the lower pivot.
Install the lower pivot collar.
BUSHING REPLACEMENT (After '06)
Press the bushing out of the lower pivot using side
"A" of the special tool.
TOOLS:
Bushing driver, 16 mm
Carefully press the bushing into the lower pivot
until the tool bottoms, using side "B" of the special
tool.
TOOLS:
Bushing driver, 16 mm
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
5.4--5.5 mm (0.21--0.22 in)
ATTACHMENT
07749-0010000
07746-0010800
07746-0041300
PILOT
LOWER PIVOT COLLAR
07AMD-HP0A100
07AMD-HP0A100
DRIVER
DUST SEALS
DRIVER
"A"
DRIVER
"B"
3/9/2008 11:07 PM