Honda 2005-2008 RX500 FA Service Manual page 476

'61HN252' by American Honda Motor Co. - Page 476 of 540
[2005-2008] [TRX500 FA/FGA]
SELECTABLE 4WD SYSTEM
Be careful not
to bend the
connector
terminals.
23-10
1 of 1
2. Front Final Clutch Line Open Circuit Inspection
Check the White/red and White/black wires for
continuity between the ECM 21P (Black) and
front final clutch 2P (Green) connector terminals.
Is there continuity?
· Open circuit in the White/red wire.
NO
· Open circuit in White/black wire.
GO TO STEP 3.
YES
3. Front Final Clutch Line Short Circuit Inspection
Check the White/red and White/black wires for
continuity between the wire harness side clutch
2P (Green) connector terminals and ground.
Is there continuity?
· Short circuit in the White/red wire.
YES
· Short circuit in White/black wire.
GO TO STEP 4.
NO
4. Front Final Clutch Inspection
Measure the resistance between the final clutch
side 2P (Green) connector terminals.
Is the resistance within 5.1 5.8 Ω (20°C/68°F)?
Faulty front final clutch.
NO
Faulty ECM.
YES
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
FINAL CLUTCH
CONNECTOR (Viewed
from the terminal side)
ECM CONNECTOR (Viewed
from the terminal side)
WIRE HARNESS SIDE FINAL
CLUTCH CONNECTOR (Viewed
from the terminal side)
FINAL CLUTCH CONNECTOR
(Viewed from the terminal side)
W/R W/Bl
3/9/2008 11:26 PM