Honda 2005-2008 RX500 FA Service Manual page 264

'61HN252' by American Honda Motor Co. - Page 264 of 540
[2005-2008] [TRX500 FA/FGA]
CRANKSHAFT/AUTOMATIC TRANSMISSION
13-14
1 of 1
Remove the shift drum and countershaft bearings
with the special tools.
TOOLS:
Shift drum bearing:
Bearing remover, 17 mm 07936-3710300
Remover handle 07936-3710100
Remover weight 07741-0010201 or
07936-371020 or
07936-371020A
(U.S.A. only)
Countershaft bearing:
Bearing remover, 20 mm 07936-3710600
Remover handle 07936-3710100
Remover weight 07741-0010201 or
07936-3710200 or
07936-371020A
(U.S.A. only)
Apply engine oil to new bearings.
Drive the following bearings in with the marking
side facing up using the special tools.
TOOLS:
Mainshaft bearing:
Driver 07749-0010000
Attachment, 52 x 55 mm 07746-0010400
Pilot, 30 mm 07746-0040700
Countershaft bearing:
Driver 07749-0010000
Attachment, 42 x 47 mm 07746-0010300
Pilot, 20 mm 07746-0040500
Shift drum bearing:
Driver 07749-0010000
Attachment, 37 x 40 mm 07746-0010200
Pilot, 17 mm 07746-0040400
Balancer bearing:
Driver 07749-0010000
Attachment, 37 x 40 mm 07746-0010200
Pilot, 17 mm 07746-0040400
FRONT CRANKCASE
Remove the oil pump (page 4-12).
Drive output shaft and crankshaft bearings out of
the front crankcase.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
COUNTERSHAFT
BEARING
PILOT
OUTPUT SHAFT
BEARING
SHIFT DRUM
BEARING
BEARING REMOVER
DRIVER
ATTACHMENT
BALANCER
BEARING
CRANKSHAFT
BEARING
3/9/2008 11:01 PM