Honda 2005-2008 RX500 FA Service Manual page 146

'61HN252' by American Honda Motor Co. - Page 146 of 540
[2005-2008] [TRX500 FA/FGA]
COOLING SYSTEM
THERMOSTAT
6-10
1 of 1
Install the fan shroud/motor assembly onto the radi-
ator and tighten the three bolts.
Clamp the fan motor wire.
RADIATOR INSTALLATION
Install the radiator/cooling fan assembly, aligning
the lower mounting bosses with the holes in the
frame.
Install and tighten the two mounting bolts.
Connect the upper and lower radiator hoses, and
tighten the hose band screws.
Connect the fan motor breather hose.
Route the fan motor wire and breather hose prop-
erly (page 1-22).
Connect the fan motor 2P connector.
Install the accessory socket 2P connector onto the
stay of the fan motor shroud.
Connect the siphon hose to the radiator.
Install the oil cooler (page 4-7).
Fill and bleed the cooling system (page 6-5).
REMOVAL
Drain the coolant from the engine (page 6-5).
Remove the fuel tank cover (page 2-6).
Loosen the band screw and remove the air intake
duct from the air cleaner housing.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
BOLTS
CLAMP
MOUNTING BOLTS
LOWER RADIATOR HOSE
FAN MOTOR 2P
ACCESSORY SOCKET
CONNECTOR
2P CONNECTOR
INTAKE DUCT
SHROUD/MOTOR
ASSEMBLY
UPPER RADIATOR
HOSE
BREATHER
HOSE
BOSSES
SIPHON HOSE
BAND SCREW
3/9/2008 10:47 PM