Honda 2005-2008 RX500 FA Service Manual page 312

'61HN252' by American Honda Motor Co. - Page 312 of 540
[2005-2008] [TRX500 FA/FGA]
REAR WHEEL/SUSPENSION
15-8
1 of 1
Apply grease to the needle rollers of a new bearing.
Carefully press the needle bearing in the lower pivot
until the depth from the lower pivot outer surface is
5.4-5.5 mm (0.21-0.22 in), using the special tools.
TOOLS:
Driver shaft
Attachment, 22 x 24 mm
Pilot, 16 mm
Apply grease to new dust seal lips and install them
into the lower pivot.
Install the lower pivot collar.
BUSHING REPLACEMENT (After '06)
Press the bushing out of the lower pivot using side
"A" of the special tool.
TOOLS:
Bushing driver, 16 mm
Carefully press the bushing into the lower pivot
until the tool bottoms, using side "B" of the special
tool.
TOOLS:
Bushing driver, 16 mm
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
5.4--5.5 mm (0.21--0.22 in)
ATTACHMENT
07949-3710001
07746-0010800
07746-0041300
PILOT
PIVOT COLLAR
07AMD-HP0A100
07AMD-HP0A100
DRIVER
DUST SEALS
BEARING
DRIVER
"A"
DRIVER
"B"
3/9/2008 11:08 PM