Honda 2005-2008 RX500 FA Service Manual page 341

'61HN252' by American Honda Motor Co. - Page 341 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
Remove the snap ring.
Drive the bearing out of the brake panel.
Drive a new bearing into the brake panel with its
sealed side facing out (facing the axle housing)
using the special tools as shown.
TOOLS:
Driver
Oil seal driver attachment
Pilot, 28 mm
Install the snap ring into the groove.
Pack a new dust seal lips with grease.
Install the dust seal into the brake panel until it flush
with the brake panel.
Apply grease to the new brake cam dust seal lips.
Install the dust seal until it is seated.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
07749-0010000
07JAD-PH80101
07746-0041100
BEARING
BRAKE SYSTEM
SNAP RING
BEARING
DRIVER
ATTACHMENT/PILOT
SNAP RING
BEARING
AXLE DUST SEAL
BRAKE CAM DUST SEAL
16-23
3/9/2008 11:11 PM