Honda 2005-2008 RX500 FA Service Manual page 271

'61HN252' by American Honda Motor Co. - Page 271 of 540
[2005-2008] [TRX500 FA/FGA]
SERVICE INFORMATION
GENERAL
· A jack or other support is required to support the vehicle.
· Adjust toe whenever the tie-rod, knuckle or steering shaft are replaced or removed
· Do not twist or bend the brake hose and pipe when serving.
· Use genuine Honda replacement bolts and nuts for all suspension pivots and mounting points.
· Refer to
· Refer to
SPECIFICATIONS
Minimum tire tread depth
Cold tire pressure
Tie-rod distance between the ball joints
Toe
Suspension spring pre-load adjuster standard position
(CM type only)
TORQUE VALUES
Handlebar lower holder nut
Front wheel nut
Front wheel hub nut
Front brake disc bolt
Shock absorber mounting nut
Upper arm pivot nut
Lower arm pivot nut
Upper and lower arm ball joint nut
Brake hose clamp bolt
Tie-rod ball joint nut
Assist headlight case mounting nut
Steering shaft end nut
Steering shaft holder bolt
1 of 1
16-3 for brake system information.
22-10 for handlebar switch inspection.
ITEM
Standard
Minimum
Maximum
With cargo
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
FRONT WHEEL/SUSPENSION/STEERING
(page 3-26).
STANDARD
25 kPa (0.25 kgf/cm , 3.6 psi)
2
22 kPa (0.22 kgf/cm , 3.2 psi)
2
28 kPa (0.28 kgf/cm , 4.0 psi)
2
25 kPa (0.25 kgf/cm , 3.6 psi)
2
387 mm (15.2 in)
Toe-out: 30 ± 15 mm (1 - 3/16 ± 9/16 in)
Position 2
39 N·m (4.0 kgf·m, 29 lbf·ft)
64 N·m (6.5 kgf·m, 47 lbf·ft)
78 N·m (8.0 kgf·m, 58 lbf·ft)
42 N·m (4.3 kgf·m, 31 lbf·ft)
44 N·m (4.5 kgf·m, 33 lbf·ft)
44 N·m (4.5 kgf·m, 33 lbf·ft)
44 N·m (4.5 kgf·m, 33 lbf·ft)
54 N·m (5.5 kgf·m, 40 lbf·ft)
12 N·m (1.2 kgf·m, 9 lbf·ft)
54 N·m (5.5 kgf·m, 40 lbf·ft)
25 N·m (2.6 kgf·m, 19 lbf·ft)
108 N·m (11.0 kgf·m, 80 lbf·ft)
32 N·m (3.3 kgf·m, 24 lbf·ft)
SERVICE LIMIT
4.0 mm (0.16
in)
Lock nut: replace with a new one
Castle nut
ALOC bolt: replace with a new one
Lock nut: replace with a new one
Lock nut: replace with a new one
Lock nut: replace with a new one
Castle nut
Lock nut: replace with a new one
Lock nut: replace with a new one
14-3
3/9/2008 11:02 PM