Honda 2005-2008 RX500 FA Service Manual page 162

'61HN252' by American Honda Motor Co. - Page 162 of 540
[2005-2008] [TRX500 FA/FGA]
ENGINE REMOVAL/INSTALLATION
7-12
1 of 1
Connect the angle sensor and control motor con-
nectors, and secure their wires with the wire clip
and band.
Connect the crankcase breather hose to cylinder.
Install the starter motor cable onto the terminal and
tighten the nut.
Install the ground cable and tighten the bolt.
Install the rubber cap over the terminal properly.
Install the ground cable terminal onto the engine
and tighten the bolt.
Adjust the tie-rod length of the gearshift lever link-
age (page 12-18).
Install the following:
heat guard (page 8-6)
carburetor (page 5-18)
exhaust system (page 5-6)
right and left inner fender (page 2-9)
right and left front mud guards (page 2-8)
right and left center mud guards (page 2-7)
Fill the oil tank with recommended engine oil
3-14).
Fill and bleed the cooling system (page 6-5).
Check the engine oil level (page 3-12).
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
WIRE BAND
RUBBER BOOT
STARTER MOTOR CABLE
(page
CONTROL MOTOR
CONNECTOR
ANGLE
SENSOR
CONNECTOR
WIRE CLIP
BREATHER HOSE
GROUND CABLE
NUT
BOLT
GROUND CABLE TERMINAL
BOLT
3/9/2008 10:49 PM