Honda 2005-2008 RX500 FA Service Manual page 208

'61HN252' by American Honda Motor Co. - Page 208 of 540
[2005-2008] [TRX500 FA/FGA]
CENTRIFUGAL CLUTCH
10-10
1 of 1
Remove the centrifugal clutch assembly using the
special tool.
TOOL:
Outside screw puller, 07ZMC-HN20100 or
40 x 1.5 mm 07ZMC-HN2A100
(U.S.A. only)
Remove the washer.
INSPECTION
ONE-WAY CLUTCH
Hold the clutch drum and turn the drive plate.
The drive plate should turn counterclockwise
smoothly and should not turn clockwise.
Remove the drive plate assembly from the clutch
drum by turning it counterclockwise.
CLUTCH DRUM
Check the one-way clutch sprag for abnormal wear,
damage or irregular movement.
Remove the sprag clutch from the clutch outer.
Check the clutch lining and sprag clutch contacting
surfaces for abnormal wear or damage.
Measure the clutch drum I.D.
SERVICE LIMIT: 150.4 mm (5.92 in)
Check the crankshaft sliding surface of the clutch
drum boss for scratches or abnormal wear.
Measure the clutch drum boss I.D.
SERVICE LIMIT: 29.05 mm (1.144 in)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
CENTRIFUGAL CLUTCH ASSEMBLY
PULLER
CLUTCH DRUM
DRIVE PLATE
SPRAG CLUTCH
3/9/2008 10:54 PM