Honda 2005-2008 RX500 FA Service Manual page 249

'61HN252' by American Honda Motor Co. - Page 249 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
Remove the cotter pin and washer. Be sure to center
the slide shaft of the spring guide slot when the
gear position is in neutral.
If it is not centered, loosen the lock nuts on the tie-
rod B and adjust the slide shaft position by turning
the tie-rod B.
Install the washer and secure the slide shaft with a
new cotter pin.
Tighten all the tie-rod lock nuts.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Install the following:
front fender (page 2-11)
left front mud guard (page 2-8)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
SUB-TRANSMISSION/GEARSHIFT LINKAGE
SLIDE SHAFT
SLOT
TIE-ROD B
COTTER PIN
WASHER
12-19
3/9/2008 10:59 PM