Honda 2005-2008 RX500 FA Service Manual page 292

'61HN252' by American Honda Motor Co. - Page 292 of 540
[2005-2008] [TRX500 FA/FGA]
FRONT WHEEL/SUSPENSION/STEERING
14-24
1 of 1
Apply grease to a new inner dust seal lip and install
it until it is fully seated, being careful not to damage
the lips.
TOOLS:
Driver 07749-0010000
Oil seal driver 07JAD-PH80101
INSTALLATION
Apply grease to the pivot collar and install it into the
upper arm.
Apply grease to the new dust seal cap lips and
install them onto the upper arm.
Install the upper arm into the frame with the pivot
bolt and a new nut, and tighten the nut.
TORQUE: 44 N·m (4.5 kgf·m, 33 lbf·ft)
Connect the shock absorber to the upper arm with
the lower mounting bolt and a new nut, and tighten
the nut.
TORQUE: 44 N·m (4.5 kgf·m, 33 lbf·ft)
Install the lower arm into the frame with the two
pivot bolts and the new nuts, and loosely tighten
the nuts.
Install the brake hose clamps and tighten the brake
hose clamp bolts.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
OIL SEAL DRIVER
PIVOT BUSHINGS
UPPER NUT/BOLT
LOWER NUTS/BOLTS
BOLTS
DRIVER
INNER DUST SEAL
PIVOT COLLAR
DUST SEAL CAPS
SHOCK ABSORBER
LOWER MOUNTING
NUT/BOLT
3/9/2008 11:04 PM