Honda 2005-2008 RX500 FA Service Manual page 382

'61HN252' by American Honda Motor Co. - Page 382 of 540
[2005-2008] [TRX500 FA/FGA]
FRONT DRIVING MECHANISM
17-34
1 of 1
Connect the front final clutch 2P (Green) connector
and install it onto the clutch cover stay.
Install the rear speed sensor, clutch cover stay and
three bolts, and tighten the bolts to the specified
torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Clamp the rear speed sensor wire and front final
clutch wire.
Install the clutch cover while hooking it on the boss
on the case, and install and tighten the two bolts to
the specified torque.
TORQUE: 7 N·m (0.7 kgf·m, 5.1 lbf·ft)
Install the front speed sensor, guard plate and two
bolts, and tighten the bolts.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Install the following:
front fender/inner fender (page 2-11)
left drive shaft (page 17-7)
Fill the differential with the recommended oil (page
3-19).
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
2P(GREEN) CONNECTOR
REAR SPEED SENSOR
BOLTS
HOOK
CLUTCH COVER
BOLTS
BOLTS
FRONT SPEED SENSOR
CLAMP
GUARD PLATE
3/9/2008 11:15 PM