Honeywell SYA14 Series Manual page 48

3. Push the socket contact into the correct slot in the connector. Tabs on the sides of
the socket contact will expand into slots and hold the socket contact in place when
properly seated.
Remove a socket contact from the connector as follows:
1. Remove the cover from the plug.
2. Unscrew the contact receptacle.
3. Using the removal tool, slide over socket contact and push until the spring releases
the socket contact; remove socket contact.
Change the position of the plug as follows:
1. Unscrew the socket contact receptacle.
2. Pull out and rotate the receptacle to change the position of the polarizing slot
3. Install the socket contact receptacle.
Figure 4-2 The position of the connector can be adjusted with a 15° angular pitch
15°
50.0 / 1.97
WRONG CONNECTOR HANDLING
Do NOT change the connector position when it is installed on the light curtain. The
position of the connector polarizing slot is defined when assemblying the connector.
Failure to comply with these instructions may result in product damage.
48
107031-23 EN FR26 GLO 1199 Printed in France