Honeywell SYA14 Series Manual page 143

Using Soap and Water
POWER APPLIED TO MACHINE CONTROL SYSTEM
Turn off and disconnect power from FF-SB Series light curtain and machine.
Failure to comply with these instructions could result in death or serious injury.
FF-SB SERIES LIGHT CURTAIN FRONT PLATE AND FINISH DAMAGE
Do NOT use solvents to clean emitter or receiver to prevent damage to clear plastic front plate
and paint finish.
Failure to comply with these instructions may result in product damage.
1. Turn off and disconnect power to the light curtain and machine.
2. Dampen a soft, clean, non-abrasive cloth in the solution of mild soap and water. Squeeze
excess solution from the cloth.
3. Wipe the soiled areas gently with the damp cloth. Do not rub hard to prevent scratching
the clear plastic front plate or paint finish.
4. Rinse the cloth in clean water and gently wipe off any excess soap.
5. Dry the emitter and receiver with a soft, dry, non-abrasive cloth. Ensure there is no
moisture left on the emitter and receiver units before power is applied.
6. Connect power to the machine and light curtain.
7. Perform the operational test to ensure proper functional readiness.
62 Honeywell • MICRO SWITCH Sensing and Control
FF-SB Series Installation Manual
For application help: call 1-800-537-6945