Honeywell SYA14 Series Manual page 392

FF-SPS4 Series Installation Manual
Perimeter Guarding Device Removal (Terminal Strip Version Only)
POWER APPLIED TO MACHINE CONTROL SYSTEM
Turn off and disconnect power from FF-SPS4 Series perimeter guarding device and machine.
Failure to comply with these instructions could result in death or serious injury.
1. Turn off and disconnect power to the perimeter guarding system and the machine.
2. Remove the perimeter guarding device (emitter or receiver) from its mounting and place it
on a clean, level working surface.
3. Using a #15 TORX driver, loosen the four captive screws on the side of the unit (see figure
4-2). The captive screws cannot be removed from the cover.
4. Remove the cover.
5. Identify all connected wires (see figure 4-4). Refer to the inside cover for connection point
designations.
CAUTION
CONNECTOR DAMAGE
• Do NOT pull on wires during removal to prevent irreversible connector damage.
• Always push the orange tab first before removing a wire.
Failure to comply with these instructions may result in product damage.
6. Push on the orange connector tab and remove each wire by pulling the wire gently from
the connector.
7. Remove the black screw located outside of the device to release the cable; then remove
the cable from the conduit.
Figure 4-4 Wire Disconnection
For application help: call 1-800-537-6945
Inspection and Maintenance
Honeywell • MICRO SWITCH Sensing and Control 45