Honeywell SYA14 Series Manual page 144

FF-SB Installation Manual
Cleaning the Mirrors
FF-SBMIR SERIES MIRROR DAMAGE
Use soft, clean, non-abrasive cloth to clean dust or dirt from mirror to prevent scratching
surface.
Failure to comply with these instructions may result in product damage.
1. Dampen a soft, clean, non-abrasive cloth with 90% alcohol or white spirit.
2. Wipe the face of the mirror gently with the damp cloth. Do not rub hard to prevent
scratching the finish.
3. Dry the mirror with a soft, dry, non-abrasive cloth. Ensure there is no moisture or lint left
on the mirrors.
4. Perform the operational test to ensure proper functional readiness.
Repair and Maintenance
This section provides step-by-step instructions related to repair and maintenance..
The tools required include a Philips head screw driver and a #20 Torx driver.
WARRANTY CONDITIONS
Repair and maintenance are limited only to : power supply module replacement, optical
controller module replacement, and fuse replacement.
Please send back the board to Honeywell for repair.
Failure to comply with these instructions could result in death or serious injury.
Interchangeability
Emitter and receiver units are not matched. An emitter unit from one FF-SB system may be
used with the receiver unit from another if the catalog listings of the units are the same. If a
replacement for one part of a FF-SB system is required, maintenance time is greatly reduced.
For application help: call 1-800-537-6945
Honeywell • MICRO SWITCH Sensing and Control 63