Honeywell SYA14 Series Manual page 459

Snap Action Cable Pull Safety Limit Switch
REQUIRED CABLE TENSION ADJUSTMENT
• Tighten turnbuckle until middle of wide tension
indicator line on switch plunger is aligned with end
of guide bushing (Figure 7).
• Periodically check and adjust cable tension as
necessary.
Figure 7: Cable Tension at Proper Setting
IMPROPER INSTALLATION
Ensure both heads of the Maintained duplex
version are under proper tension.
Failure to comply with these instructions
could result in death or serious injury.
With endspring installed, switch/cable will operate
satisfactorily over temperature range of +/- 25°F
(+/- 12°C), up to maximum cable length of 200 ft
(60 m).
Adjust cable tension when ambient temperature is
near mid point of expected temperature extremes.
OPTIONAL CORNER INSTALLATION
When changing actuating cable direction, ensure
cable runs freely through pulley or cable supports.
MICRO SWITCH
Honeywell Inc.
11 West Spring Street
Freeport, Illinois 61032
P rinted w ith Soy Ink
on 50% R ecycled Paper
PK 81592-3-ML IL50 GLO 598 Printed in USA
REPOSITION OPERATING HEAD
Head may be positioned in any of four directions.
• Using the driver provided, loosen the four captive
security screws.
• Place head in desired position.
• Securely tighten the four screws to 12-16 in-lb
(1,36-1,80 N-m).
RECOMMENDED REPLACEMENT
Key
1. Guide
Replace entire switch every 10,000 operations.
bushing
2. Tension
WARRANTY/REMEDY
indicator line
Honeywell warrants goods of its manufacture as
being free of defective material and faulty
workmanship. Contact your local sales office for
warranty information. If warranted goods are
returned to Honeywell during that period of
coverage, Honeywell will repair or replace without
charge those items it finds defective. The foregoing
is Buyer's sole remedy and is in lieu of all other
warranties, expressed or implied, including
those of merchantability and fitness for a
particular purpose.
While we provide application assistance,
personally and through our literature, it is up to the
customer to determine the suitability of the product
in the application
Specifications may change at any time without
notice. The information we supply is believed to be
accurate and reliable as of this printing. However,
we assume no responsibility for its use.
1-800-537-6945 USA
+44 (0) 161 251 4079 UK
+33 (0) 4 76 41 7200 France
+49 (0) 69 8064 444 Germany
1-800-737-3360 Canada
1-815-235-6847 International
FAX
1-815-235-6545 USA
INTERNET
http://www.honeywell.com/sensing/
info@micro.honeywell.com
PK 81592
ISSUE 3