Honeywell SYA14 Series Manual page 233

IMPROPER MULTIPLE SENSOR INSTALLATION
Even if the steps above have been followed to avoid direct interference between multiple sensors, make sure
that there cannot be indirect interferences from reflecting surfaces (mirrors, metal parts,...)
The FF-SE can be installed in any position (head up, upside down, mounted on a wall, inclined etc.).
There are two possibilities for mounting the sensor on the machine:
• 4 tapped M4 x 10 holes are available on the lower side of the sensor for horizontal mounting.
4 screws M4 x 10 (included)
Figure 4-3 : Mounting
For mounting, the following material is required:
• 4 M4 x 10 screws for mounting on a horizontal surface (included).
• Washers and lock washers (included).
• A bubble level for alignment.
• The bracket sold separately is delivered with its own mounting kit. It is recommended to use it to protect the FF-
SE.
Figure 4-4 : FF-SEZ6BRAC3 : bracket for FF-SE safety laser
25 107006-11 EN FR26 GLO 0300 Printed in Germany