Power Wiring - Honeywell SYA14 Series Manual

FF-SB Installation Manual
Install pin into connector as follows:
1. Strip about 8 mm (0.3 inch) of insulation from the wire end.
2. Using a crimping tool, crimp the pin onto the wire.
3. Push the pin into the correct slot in the connector. Tabs on the sides of the pin will expand
into slots and hold the pin in place when properly seated.
Remove a pin from the connector as follows:
1. Remove the gray plastic receptacle from the plug.
2. Remove the ground screw.
3. Using a screwdriver, pry up the edges of the plastic retainer piece on each side of the
receptacle.
4. Slide the plastic retainer up and remove it.
5. Slide the metal part on each side down, and remove it.
6. Using a screw driver in the side slots, push the top part off.
7. Using the removal tool equivalent to FG 0300-146 (Honeywell part number FG-0300-146),
slide over pin and push until the spring releases the pin; remove pin.

Power Wiring

FF-SB Series light curtains operate on either 120 or 240 volts AC. The emitter and receiver
units automatically switch to the AC voltage applied with the exception of FF-SB12E/R02E-S2
which operates on 120 VAC only.
A low voltage version (24-48 VDC) is available for the FF-SB14, FF-SB15 and FF-SB30
Series.
All of the FF-SB Series light curtains have the same connections for power. Figure 3-2 shows
the power connections. Figure 3-3 illustrates the receiver connections.
Figure 3-2 Emitter and Receiver Power Connections
Note : For VDC versions, the supply connection is the following :
For application help: call 1-800-537-6945
+
Terminal A4 :
-
Terminal A5 :
Supply Voltage
Neutral
Earth Ground
Honeywell • MICRO SWITCH Sensing and Control 47