Overview - Honeywell SYA14 Series Manual

(OHFWULFDO &RQQHFWLRQV

Overview

This chapter contains information about electrical installation and wiring.
IMPROPER INSTALLATION
Strictly adhere to all electrical connection instructions.
Failure to comply with these instructions could result in death or serious injury.
Connector Wiring
All FF-SB Series light curtains have a metal quick-disconnect connector (supplied). Emitter
units use connector FF-SBZ1721137 and the receiver units use connector FF-SBZ1721202.
Figure 3-1 illustrates a rear view of the connector (pins inserted this side). Both connectors
use the same type of crimped pins.
Figure 3-1 Rear View of Quick-Disconnect Connector
• connections are made through quick disconnect metal DIN 43652 plugs delivered with the
light curtain.
• cross sectional area of stranded wires to be crimped (metal DIN 43652 plugs only) : 0.5
mm2 (AWG20) as a minimum, 1.5 mm2 (AWG16) as a maximum.
• packing glands and allowed cable diameters to guarantee the IP65 / NEMA 4, 13 sealing
(metal DIN 43652 plugs only) : PG9 for the emitter plug (allowed cable diameters : 5.5 to 8.7
mm / 0.22 to 0.34 in.), PG21 for the receiver plug (allowed cable diameters : 11 to 19 mm /
0.44 to 0.74 in.).
Ensure the following tools are available when wiring the quick-disconnect connector:
• A set of wire strippers.
• A medium sized flat-head screwdriver.
• An FA 0100-164 (Honeywell part number FA0100-164) crimping tool or equivalent.
46 Honeywell • MICRO SWITCH Sensing and Control
FF-SB Series Installation Manual
For application help: call 1-800-537-6945