Honeywell SYA14 Series Manual page 153

Power Supply Module Replacement
1. Ensure the optical controller module and the retaining rods are correctly in place.
2. Aligning the power supply module with the slots in the housing, slide the module into the
housing until the flat cable connector can be connected to the optical controller module.
3. Push the flat cable connector straight into its receptacle, making sure the tab closes over
the edge of the connector (see figure 4-7).
4. Install the power supply module and tighten the four Torx screws using the #20 Torx
driver.
5. Install the light curtain on the machine.
6. Connect and apply power to the machine and light curtain.
7. Perform the operational test to ensure proper functional readiness.
72 Honeywell • MICRO SWITCH Sensing and Control
FF-SB Series Installation Manual
For application help: call 1-800-537-6945