Ipv6 Nd Dad Attempts; Ipv6 Nd Hop-Limit - HP A5120 EI Series Command Reference Manual

Description
Use the ipv6 nd autoconfig other-flag command to set the other stateful configuration flag (O) to 1 so that
the host can acquire information other than IPv6 address through stateful autoconfiguration (for example,
from a DHCP server).
Use the undo ipv6 nd autoconfig other-flag command to restore the default.
By default, the O flag is set to 0 so that the host can acquire other information through stateless
autoconfiguration.
Examples
# Configure the host to acquire information other than IPv6 address through stateless autoconfiguration.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] undo ipv6 nd autoconfig other-flag

ipv6 nd dad attempts

Syntax
ipv6 nd dad attempts value
undo ipv6 nd dad attempts
View
Interface view
Default level
2: System level
Parameters
value: Specifies the number of attempts to send an NS message for DAD, in the range 0 to 600. The
default value is 1. When it is set to 0, DAD is disabled.
Description
Use the ipv6 nd dad attempts command to configure the number of attempts to send an NS message for
DAD.
Use the undo ipv6 nd dad attempts command to restore the default.
By default, the number of attempts to send an NS message for DAD is 1.
Related commands: display ipv6 interface.
Examples
# Set the number of attempts to send an NS message for DAD to 20.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd dad attempts 20

ipv6 nd hop-limit

Syntax
ipv6 nd hop-limit value
164