Qinq Ethernet-Type - HP 3100 v2 Series Command Reference Manual

[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] qinq enable downlink
# Enable selective QinQ on port group 1.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member ethernet 1/0/1 to ethernet 1/0/6
[Sysname-port-group-manual-1] qinq enable downlink

qinq ethernet-type

Syntax
qinq ethernet-type hex-value
undo qinq ethernet-type
View
System view
Default level
2: System level
Parameters
hex-value: Specifies a hexadecimal tag protocol identifier (TPID) value, ranging from 0x0001 to
0xFFFF. However, do not set it to any of the protocol type values listed in
Table 42 Common protocol type values
Protocol type
ARP
PUP
RARP
IP
IPv6
PPPoE
MPLS
IPX/SPX
IS-IS
LACP
802.1X
Cluster
Reserved
Description
Use qinq ethernet-type to configure the TPID value in VLAN tags.
Use undo qinq ethernet-type to restore the TPID value in VLAN tags to the system default.
By default, the TPID value in VLAN tags is 0x8100.
Value
0x0806
0x0200
0x8035
0x0800
0x86DD
0x8863/0x8864
0x8847/0x8848
0x8137
0x8000
0x8809
0x888E
0x88A7
0xFFFD/0xFFFE/0xFFFF
183
Table 42.