State Monitor For Intercom Contact Configuration; Outgoing Intercom Configuration - Yealink SIP-T2 Series Administrator's Manual

State Monitor for Intercom Contact Configuration

The following table lists the parameters you can use to configure state monitor for intercom contact.
Parameter features.intercom.led.enable
It enables or disables the IP phone to display different intercom DSS key LED status/icons when the
status of monitored user changes.
Description
Note: It works only if "features.intercom.subscribe.enable" is set to 1 (Enabled). It is not applicable to
T19(P) E2/CP920 IP phones.
Permitted 0-Disabled
Values 1-Enabled
Default 0
Parameter features.intercom.subscribe.enable
It enables or disables intercom subscription for the IP phone.
Description
Note: It is not applicable to T19(P) E2/CP920 IP phones.
Permitted 0-Disabled
Values 1-Enabled
Default 0

Outgoing Intercom Configuration

Yealink IP phones support two methods for initialing intercom calls.
The following table lists the parameters you can use to configure outgoing intercom.
Parameter features.intercom.mode
Description It configures the intercom mode.
0-SIP
Permitted
Values
1-FAC, the feature access code is configured by the parameter "features.intercom.feature_access_code".
Default 0
Parameter features.intercom.feature_access_code
It configures the intercom feature access code.
Description
Note: It works only if "features.intercom.mode" is set to 1 (FAC).
Permitted
String
Values
Default Blank
Parameter account.X.call_info
It configures the Call-Info header for intercom feature.
The value format likes:
Description
<sip:notused>; answer-after=0
Note: If both Call-Info header and Alert-Info header (defined by the parameter "account.X.alert_info") are
configured, the Call-Info header has a higher priority than the Alert-Info header.
Permitted String within 256 characters
[1]
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<MAC>.cfg
Advanced Features
437