Resetting The Ip Phone To Default Factory Settings; Resetting The Ip Phone To Custom Factory Settings; Custom Factory Configuration - Yealink SIP-T2 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
Parameter features.reset_by_long_press_enable
Description It enables or disables the IP phone to reset to factory by long pressing OK/√key.
Permitted
0-Disabled
1-Enabled
Values
Default 1
Parameter features.factory_pwd_enable
It enables or disables the IP phone to prompt for the administrator password when you long press the
Description
OK/√key to perform factory reset on the idle screen.
Permitted
0-Disabled
1-Enabled
Values
Default 0

Resetting the IP phone to Default Factory Settings

Procedure
1. Click Settings->Upgrade.
2. Click Reset to Factory in the Reset to Factory field.
The web user interface prompts the message "Do you want to reset to factory?".
3. Click OK to confirm the resetting.
The IP phone will be reset to factory successfully after startup.
Note
Reset of your phone may take a few minutes. Do not power off until the phone starts up successfully.

Resetting the IP phone to Custom Factory Settings

After you enable the custom factory feature, you can import the custom factory configuration file, and then reset the
IP phone to custom factory settings.
Procedure
1. From the web user interface, click Settings->Configuration.
2. In the Import Factory Config block, click Browse to locate the custom factory configuration file from your local
system.
3. Click Import.
4. After custom factory configuration file is imported successfully, you can reset the IP phone to custom factory set-
tings.
Topic

Custom Factory Configuration

Custom Factory Configuration
The following table lists the parameters you can use to configure custom factory.
Parameter static.features.custom_factory_config.enable
522
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg