Incoming Intercom Configuration - Yealink SIP-T2 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
Values
Default Blank
[1]
X is the account ID. For T54S/T48S/T48G/T46S/T46G/T29G, X=1-16; for T52S/T42G/T42S, X=1-12; for T41P/T41S/T27G,
X=1-6; for T40P/T40G/T23P/T23G, X=1-3; for T21(P) E2, X=1-2; for T19(P) E2/CP920, X=1.

Incoming Intercom Configuration

The IP phone can process incoming calls differently depending on settings.
The following table lists the parameters you can use to configure incoming intercom.
Parameter features.intercom.allow
Description It enables or disables the IP phone to answer an incoming intercom call.
0-Disabled, the IP phone will handle an incoming intercom call like a normal incoming call.
Permitted
Values
1-Enabled, the IP phone will automatically answer an incoming intercom call.
Default 1
Web UI Features->Intercom->Intercom Allow
Phone UI Menu->Features->Intercom->Intercom Allow
Parameter features.intercom.mute
It enables or disables the IP phone to mute the microphone when answering an intercom call.
Description
Note: It works only if "features.intercom.allow" and "features.allow_mute" are set to 1 (Enabled).
0-Disabled
Permitted
Values
1-Enabled, the microphone is muted for intercom calls, and then the other party cannot hear you.
Default 0
Web UI Features->Intercom->Intercom Mute
Phone UI Menu->Features->Intercom->Intercom Mute
Parameter features.intercom.tone
It enables or disables the IP phone to play a warning tone when answering an intercom call.
Description
Note: It works only if "features.intercom.allow" is set to 1 (Enabled).
Permitted
0-Disabled
1-Enabled
Values
Default 1
Web UI Features->Intercom->Intercom Tone
Phone UI Menu->Features->Intercom->Intercom Tone
Parameter features.intercom.barge
It enables or disables the IP phone to answer an incoming intercom call while there is already an active
call on the IP phone.
Description
Note: It works only if "features.intercom.allow" and "call_waiting.enable" are set to 1 (Enabled) and
"phone_setting.call_appearance.calls_per_linekey" is greater than 1.
Permitted 0-Disabled, the IP phone will handle an incoming intercom call like a normal incoming call while there is
438
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg