Network Reachability Detection Configuration - Yealink SIP-T2 Series Administrator's Manual

You can also diagnose network via phone user interface at the path: Menu->Features->Diagnostics->Network->Ping
or Menu->Features->Diagnostics->Network->Trace Route.

Network Reachability Detection Configuration

The following table lists the parameters you can use to configure network reachability detection.
Parameter static.features.network_test.enable
Description It enables or disables the network reachability detection.
0-Disabled
Permitted
1-Enabled, if the network is unreachable, "Network unreachable" is displayed on the T42S/T41S IP
Values
phones, while a network unreachable icon is displayed in the status bar of other IP phones.
Default 0
Parameter static.features.network_test.host
It configures the server address that the phone uses to detect the network reachability.
The server address can be the IP address or domain name. Multiple server addresses are separated by semi-
colons.
Description
Example:
static.features.network_test.host = 192.168.1.20;192.168.1.10
Note: It works only if "static.features.network_test.enable" is set to 1 (Enabled).
Blank-The phone does not detect network reachability.
Permitted
Values
String within 1024 characters
Default Blank
Parameter static.features.network_test.check_policy
It configures the policy when detecting the network reachability of multiple servers.
Description
Note: It works only if "static.features.network_test.enable" is set to 1 (Enabled).
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
Troubleshooting Methods
527