Dual Headset Configuration; Acoustic Clarity Technology; Acoustic Echo Cancellation (Aec); Aec Configuration - Yealink SIP-T2 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones

Dual Headset Configuration

Dual Headset Configuration
The following table lists the parameter you can use to configure dual headset.
Parameter features.headset_training
It enables or disables the dual headset feature.
Description
Note: It works only if "features.headset_mode.enable" is set to 1 (Enabled). It is not applicable to CP920 IP
phones.
0-Disabled
Permitted
1-Enabled, users can use two headsets on one phone. When the IP phone joins a call, the users with the
Values
headset connected to the headset jack have a full-duplex conversation, while the users with the headset
connected to the handset jack are only allowed to listen to.
Default 0
Web UI Features->General Information->Dual Headset

Acoustic Clarity Technology

To optimize the audio quality of your network, Yealink IP phones support the acoustic clarity technology: Acoustic
Echo Cancellation (AEC), Background Noise Suppression (BNS), Automatic Gain Control (AGC), Voice Activity Detec-
tion (VAD), Comfort Noise Generation (CNG) and jitter buffer.
Topics

Acoustic Echo Cancellation (AEC)

Noise Suppression
Background Noise Suppression (BNS)
Automatic Gain Control (AGC)
Voice Activity Detection (VAD)
Comfort Noise Generation (CNG)
Jitter Buffer
Smart Noise Block
Acoustic Echo Cancellation (AEC)
Yealink IP phones employ advanced AEC for hands-free operation. You can configure the AEC feature to remove the
echo of the local loudspeaker from the local microphone without removing the near-end speech.
AEC is not normally required for calls via the handset. In some cases, where echo is experienced by the remote party,
AEC may be used to reduce/avoid echo when you use the handset.
Note
Utilizing acoustic echo cancellation will introduce a small increase of delay into an audio path which might cause a lower
voice quality.
Topic

AEC Configuration

AEC Configuration
The following table lists the parameter you can use to configure AEC.
358
<y0000000000xx>.cfg