State Monitor For Intercom Contact; State Indicator Of Intercom Contact - Yealink SIP-T2 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
Line Key Configuration Programmable Key Configuration
linekey.X.type = 14
programablekey.X.type = 14
linekey.X.line = 1
programablekey.X.line = 1
linekey.X.value = 4603
programablekey.X.value = 4603
linekey.X.label = Bill
After provisioning, an Intercom key for Bill (4603) is available on the phone. You can press the Intercom key to place an
intercom call to Bill (4603).
If you want to use the Intercom key to pick up a call, you need to enable the Intercom key to monitor state changes,
and configure the pickup code for the Intercom key, for example, set "linekey.X.extension = *97" or "pro-
gramablekey.X.extension = *97". When the monitored user Bill (4603) receives an incoming call, you can press the Inter-
com key to pick up the call to Bill (4603) directly.
Note
You cannot use a programmable key to monitor an intercom contact for state changes, but press it to pick up a call.
Related Topics
Line Keys Configuration
Programmable Keys Configuration

State Monitor for Intercom Contact

State Monitor for Intercom Contact
You can make the phone to monitor a specific intercom user for state changes (busy or idle). When the monitored user
receives an incoming call, the supervisor can press the intercom key to pick up the call directly. IP phones support this
feature using a SUBSCRIBE/NOTIFY mechanism as specified in
Note
If you want to use the Intercom key to pick up a call, you need to configure the pickup code for the Intercom key, for
example, "linekey.X.extension = *97".
Topics

State Indicator of Intercom Contact

State Monitor for Intercom Contact Configuration
State Indicator of Intercom Contact
The following table shows the LED indicator associated with the Intercom key:
LED Status
Solid green
Fast-flashing red (200ms) The monitored user receives an incoming call.
Solid red
Off
436
Description
The monitored user is idle.
The monitored user is dialing.
The monitored user is talking.
The monitored user does not exist.
RFC 3265. It is not available on the T19(P) E2 IP phone.