Tones - Yealink SIP-T2 Series Administrator's Manual

Note: We recommend that you modify this parameter cautiously. A suitable value may render the voice
quality bad. It is not applicable to CP920 IP phones.
Permitted
Integer from -50 to 50
Values
Default 0
Web UI Features->Audio->Handset Send Volume (-50~50)
Parameter voice.handset.autoreset_spk_vol
It configures the handset's volume level during a call.
Description
Note: It is not applicable to CP920 IP phones.
0-The handset volume at the end of a call persists between calls.
Permitted
1 to 15-The handset volume does not persist between calls, and resets to this specified level each new
Values
call.
Default 0
Parameter voice.headset_send
It configures the sending volume of the headset.
Description
Note: We recommend that you modify this parameter cautiously. A suitable value may render the voice
quality bad. It is not applicable to CP920 IP phones.
Permitted
Integer from -50 to 50
Values
Default 0
Web UI Features->Audio->Headset Send Volume (-50~50)
Parameter voice.headset.autoreset_spk_vol
Description It configures the headset's volume level during a call.
0-The headset volume at the end of a call persists between calls.
Permitted
Values
1 to 15-The headset volume does not persist between calls, and resets to this specified level each new call.
Default 0
Parameter voice.side_tone
Description It configures the volume of the side tone.
Permitted
Integer from -100 to 0
Values
Default -25
[1]
If you change this parameter, the IP phone will reboot to make the change take effect.

Tones

When receiving a message, the IP phone will play a warning tone. You can customize tones or select specialized tone
sets (vary from country to country) to indicate different conditions of the IP phone.
Topics
Supported Tones
[1]
[1]
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
Audio Features
343