Yealink SIP-T2 Series Administrator's Manual page 41

Menu->Advanced (default password: admin) ->Network->CDP->CDP Status
T42G/T42S/T41P/T41S/T40P/T40G/T27G/T23P/T23G/T21(P) E2/T19(P) E2/CP920:
Menu->Settings->Advanced Settings (default password: admin) ->Network->CDP->CDP Status
Parameter static.network.cdp.packet_interval
It configures the interval (in seconds) at which the IP phone sends the CDP (Cisco Discovery Protocol)
request.
Description
Note: It works only if "static.network.cdp.enable" is set to 1 (Enabled).
Permitted
Integer from 1 to 3600
Values
Default 60
Web UI Network->Advanced->CDP->Packet Interval (1~3600s)
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Advanced (default password: admin) ->Network->CDP->CDP Interval
Phone UI
T42G/T42S/T41P/T41S/T40P/T40G/T27G/T23P/T23G/T21(P) E2/T19(P) E2/CP920:
Menu->Settings->Advanced Settings (default password: admin) ->Network->CDP->CDP Interval
[1]If you change this parameter, the IP phone will reboot to make the change take effect.
Manual VLAN Configuration
VLAN is disabled on IP phones by default. You can configure VLAN for the Internet port and PC port manually. For
CP920 IP phones, you can only configure VLAN for the Internet port manually, because they only have Internet port.
Before configuring VLAN on the IP phone, you need to obtain the VLAN ID from your network administrator.
The following table lists the parameters you can use to configure VLAN manually.
Parameter static.network.vlan.internet_port_enable
Description It enables or disables the VLAN for the Internet port.
Permitted
0-Disabled
1-Enabled
Values
Default 0
Web UI Network->Advanced->VLAN->WAN Port->Active
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Advanced (default password: admin) ->Network->VLAN->WAN Port->VLAN Status
Phone UI
T42G/T42S/T41P/T41S/T40P/T40G/T27G/T23P/T23G/T21(P) E2/T19(P) E2/CP920:
Menu->Settings->Advanced Settings (default password: admin) ->Network->VLAN->WAN Port->VLAN
Status
Parameter static.network.vlan.internet_port_vid
It configures the VLAN ID for the Internet port.
Description
Note: It works only if "static.network.vlan.internet_port_enable" is set to 1 (Enabled).
Permitted
Integer from 1 to 4094
Values
[1]
<y0000000000xx>.cfg
[1]
<y0000000000xx>.cfg
[1]
<y0000000000xx>.cfg
Phone Network
35