Yealink SIP-T2 Series Administrator's Manual page 182

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
Macro Action
$I<menu item ID>$
$P<label>&T<title>&C<characters
number allowed>&N&M$
$P<EDK user input prompt
X>N<characters number
allowed>$
176
ExtX@Y (X stands for the serial number of expansion module key, Y stands for
l
the serial number of expansion module; For T48S/T48G/T46S/T46G/T29G: X
ranges from 1 to 40, Y ranges from 1 to 6; For T54S/T52S: X ranges from 1 to
60, Y ranges from 1 to 3; @Y can be omitted if there is only one expansion
module connected to the phone.)
Menu (You can enter menu by executing this command at any interface
l
except the non-executable situations. For example, entering menu is blocked
during an active call.)
Home (You can return back to the idle screen by executing this command on
l
the dialing screen for T48S/G IP phones)
Example: $KDialPadPound$ means pressing the pound key.
Note: If a key (for example, Redial key) is not found but the function is available,
the phone will perform the corresponding action. If a key is not found and the
function is unavailable, the execution of the action string will be ignored.
The action is to position and enter the desired menu item.
Each menu item has a unique identifier on the IP phone, you can configure this
parameter according to the system-defined menu item ID. If the menu item ID is
not defined on the phone or there is no matched menu item on the current
screen, the execution of the action string will be ignored. The menu item ID is
case-insensitive.
Example: $Istatus_list& means entering the Status menu.
Note: To view the menu item ID, you can set "edk.id_mode.enable" to 1
(Enabled) and then long press the Volume Up key when the phone is idle.
The user input prompt string.
"label" means the specified label for the user input prompt.
"title" means the specified title for the user input prompt.
"characters number allowed" defines the maximum number of input characters.
If &N is included, the character type is Number (default input method: 123). If
&N is not included, the character type is Text (default input method: abc), you
can manually change the input method.
If &M is included, the inputs are masked by the asterisk characters "*".
Example: $PPassword&C3&N&M$ means prompting a Password pop-up box,
the maximum number of input characters is 3, the input type is Number, and the
input is masked by the asterisk characters "*".
Note: &T<title> is not applicable to T48S/T48G/T46G/T42G/T41P/T29G IP
phones.
The user input prompt string.
"EDK user input prompt X" means which EDK user input prompt is invoked. It
indicates the X defined by "edk.edkprompt.X.enable".
"characters number allowed" defines the maximum number of input characters.
You need to press the Enter soft key to complete data entry.
Description