Blf Key Led/Icon And Behavior For Talking State Configuration - Yealink SIP-T2 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
Default Blank
Parameter blf.enhanced.callout.callin.action
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is ringing and monitored
user is calling out.
This value uses the same macro action string syntax as an Enhanced DSS key.
Description Example:
blf.enhanced.callout.callin.action = newcall
Note: It works only if "blf.enhanced.callout.enable" is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
String
Values
Default Blank
Parameter blf.enhanced.callout.talking.action
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is talking and monitored
user is calling out.
This value uses the same macro action string syntax as an Enhanced DSS key.
Description Example:
blf.enhanced.callout.talking.action = newcall
Note: It works only if "blf.enhanced.callout.enable" is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
String
Values
Default Blank
Parameter blf.enhanced.callout.idle.action
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is idle and monitored
user is calling out.
This value uses the same macro action string syntax as an Enhanced DSS key.
Description Example:
blf.enhanced.callout.idle.action = newcall
Note: It works only if "blf.enhanced.callout.enable" is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
String
Values
Default Blank

BLF Key LED/Icon and Behavior for Talking State Configuration

The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for talking state (the
monitored user is talking).
426
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg