Blf Key Led/Icon And Behavior For Hold State Configuration; Blf Key Led/Icon And Behavior For Dnd State Configuration - Yealink SIP-T2 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones

BLF Key LED/Icon and Behavior for Hold State Configuration

The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for hold state (the call
on the monitored phone is placed on hold).
Parameter blf.enhanced.hold.enable
It enables or disables the custom configuration when the call on the monitored phone is placed on hold.
Description
Note: It is not applicable to T48G/T46G/T42G/T41P/T29G/T19(P) E2/CP920 IP phones.
0-Disabled
Permitted
Values
1-Enabled, the IP phone will display the custom BLF/BLF List DSS key LED status/icon colors.
Default 0
Parameter blf.enhanced.hold.led
It configures the custom BLF/BLF List DSS key LED status/icon colors when the call on the monitored
phone is placed on hold.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.hold.led = $LEDg1000o$
Description
For T54S/T52S/T46S/T42S/T41S/T40P/T40G/T27G/T23P/T23G/T21(P) E2 IP phones, the BLF/BLF List DSS
key LED glows green for 1000ms and then goes out.
For T48S IP phones, the BLF/BLF List DSS key field displays a green icon for 1000ms and then turns to
white.
Note: It works only if "blf.enhanced.hold.enable" is set to 1 (Enabled). It is not applicable to
T48G/T46G/T42G/T41P/T19(P) E2/CP920 IP phones.
Permitted
String
Values
Default Blank

BLF Key LED/Icon and Behavior for DND State Configuration

The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for DND state (DND is
activated on the monitored phone).
Parameter blf.enhanced.dnd.enable
It enables or disables the custom configuration when DND is activated on the monitored phone.
Description
Note: It is not applicable to T48G/T46G/T42G/T41P/T29G/T19(P) E2/CP920 IP phones.
0-Disabled
Permitted
Values
1-Enabled, the IP phone will display the custom BLF/BLF List DSS key LED status/icon colors.
Default 0
Parameter blf.enhanced.dnd.led
It configures the custom BLF/BLF List DSS key LED status/icon colors when DND is activated on the mon-
itored phone.
Description
This value uses the same macro action string syntax as an Enhanced DSS key.
430
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg