State Indicator of Intercom Contact
The following table shows the LED indicator associated with the Intercom key:
LED Status
Solid green
Fast-flashing red (200ms) The monitored user receives an incoming call.
Solid red
Off
State Monitor for Intercom Contact Configuration
The following table lists the parameters you can use to configure state monitor for intercom contact.
Parameter features.intercom.led.enable
It enables or disables the phone to display different intercom DSS key LED status/icons when the
status of monitored user changes.
Description
Note: It works only if "features.intercom.subscribe.enable" is set to 1 (Enabled).
Permitted
0-Disabled
Values
1-Enabled
Supported
All phones except T30P, T30, T19(P) E2 and CP920
Devices
Default
0
Parameter features.intercom.subscribe.enable
Description It enables or disables intercom subscription for the phones.
Permitted
0-Disabled
1-Enabled
Values
Default
0
Supported
All phones except T30P, T30, T19(P) E2 and CP920
Devices
Outgoing Intercom Configuration
Yealink phones support two methods for initialing intercom calls.
The following table lists the parameters you can use to configure outgoing intercom.
Parameter features.intercom.mode
Description It configures the intercom mode.
0-SIP
Permitted
Values
1-FAC, the feature access code is configured by "features.intercom.feature_access_code".
Default
0
Parameter features.intercom.feature_access_code
It configures the intercom feature access code.
Description
Note: It works only if "features.intercom.mode" is set to 1 (FAC).
Description
The monitored user is idle.
The monitored user is dialing.
The monitored user is talking.
The monitored user does not exist.
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
Advanced Features
508