Yealink SIP-T2 Series Administrator's Manual page 273

It enables or disables the digit map feature for the IP phone.
Description
Note: The value configured by the parameter "account.X.dialplan.digitmap.enable" takes precedence
over that configured by this parameter.
Permitted
0-Disabled
1-Enabled
Values
Default 0
Parameter dialplan.digitmap.string
It configures the digit map pattern used for the dial plan.
Example:
dialplan.digitmap.string = <[2-9]x:86>3.T|0x.!|1xxx
Description
Note: The string must be compatible with the digit map feature of MGCP described in 2.1.5 of RFC 3435. It
works only if "dialplan.digitmap.enable" or "account.X.dialplan.digitmap.enable" is set to 1 (Enabled). The
value configured by the parameter "account.X.dialplan.digitmap.string" takes precedence over that con-
figured by this parameter.
Permitted
String within 2048 characters
Values
Default [2-9]11 | 0T | 011xxx.T | [0-1][2-9]xx xxxxxxx | [2-9]xx xxxxxxx | [2-9]xxxT | **x.T | +x.T| 00x.T
Parameter dialplan.digitmap.interdigit_long_timer
It configures the time (in seconds) for the IP phone to wait before dialing an entered number if it matches
part of any string of the digit map.
If it is set to 0, the IP phone will not dial the entered number if only a partial match exists.
The value of this parameter should be greater than that configured by the parameter "dial-
plan.digitmap.interdigit_short_timer".
For example:
dialplan.digitmap.string = 1xxT|xxxxx<T1>
dialplan.digitmap.interdigit_long_timer = 10
Description
dialplan.digitmap.interdigit_short_timer = 5
When you enter 1, it matches part of two-digit maps, the IP phone tries to wait 10 seconds and then dials
out 1 if no numbers entered;
When you enter 15, it also matches part of two-digit maps, the IP phone tries to wait 10 seconds and then
dials out 15 if no numbers entered;
When you enter 153, it also matches part of two-digit maps, the IP phone tries to wait 10 seconds. But
after waiting for 5 seconds, it completely matches the first digit map and then immediately dials out 153.
Note: It works only if "dialplan.digitmap.enable" or "account.X.dialplan.digitmap.enable" is set to 1
(Enabled). The value configured by the parameter "account.X.dialplan.digitmap.interdigit_long_timer"
takes precedence over that configured by this parameter.
Permitted
Integer from 0 to 255
Values
Default 10
<y0000000000xx>.cfg
<y0000000000xx>.cfg
Call Features
267