Multiple Line Keys Per Account; Multiple Line Keys Per Account Configuration - Yealink SIP-T2 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
Values 1-Enabled
Default 0

Multiple Line Keys per Account

You can assign multiple line keys to associate with a specific account. The line keys are automatically assigned with
Line type from the first unused one (unused one means the line key is configured as N/A or the associated account is
not registered). All calls on this account will be distributed evenly among these line keys. It is useful for managing a
high volume of calls to an account.
When you assign multiple line keys to be associated with an account, you can configure the IP phone whether trans-
ferring a call or setting up a conference call on the current line key or on a new distribution line key.
It is not applicable to T19(P) E2/CP920 IP phones.
Topics

Multiple Line Keys per Account Configuration

Auto Line Labels Rule Configuration
Default Account
Multiple Line Keys per Account Configuration
The following table lists the parameters you can use to configure multiple line keys per account.
Parameter features.auto_linekeys.enable
It enables or disables to assign multiple line keys to associate with a specific account.
Description
Note: The number of the line keys is determined by "account.X.number_of_linekey". It is not applicable to
T19(P) E2/CP920 IP phones.
Permitted
0-Disabled
Values 1-Enabled
Default 0
Web UI Features->General Information->Auto Linekeys
Parameter account.X.number_of_linekey
It configures the number of line keys to be assigned with a specific account from the first unused one. If a
line key is in used, the IP phone will skip to the next unused DSS key.
Description
Note: It is not applicable to T19(P) E2/CP920 IP phones.
Integer from 1 to 999
Permitted
The number of the line keys varies by phone models, for the supported line keys, refer to
Values
Keys.
Default 1
Web UI Account->Advanced->Number of line key
phone_setting.call_appearance.transfer_via_new_
Parameter
linekey
It enables or disables to distribute a transferring call to a new line key (the new line key is not seized). If all
Description
line keys are seized, the current line key will be used.
220
<y0000000000xx>.cfg
[1]
<MAC>.cfg
<y0000000000xx>.cfg
Supported DSS