Ip Address Call; Ip Address Call Configuration; Ignoring Incoming Calls - Yealink SIP-T2 Series Administrator's Manual

Note: If it is left blank, the IP phone will not automatically filter any characters when dialing.
Permitted
String within 99 characters
Values
Default , -()
Web UI Features->General Information->Call Number Filter

IP Address Call

You can set the phone whether to receive or place an IP call. You can neither receive nor place an IP call if you disable
this feature.
Topic

IP Address Call Configuration

IP Address Call Configuration
The following table lists the parameter you can use to configure IP address call.
Parameter features.direct_ip_call_enable
It enables or disables to allow IP address call.
Description
Note: If you want to receive an IP address call, make sure "sip.trust_ctrl" is set to 0 (Disabled).
Permitted 0-Disabled
Values 1-Enabled
Default 1
Web UI Features->General Information->Allow IP Call

Ignoring Incoming Calls

By default, when a phone receives an incoming call, the phone screen prompts the incoming call information. You
should handle the incoming call first before performing other features. For example, you should handle the incoming
call when there is an active call in progress, otherwise you cannot hold or set up a conference on the current call.
You can configure the phone to ignore an incoming call. The incoming call is still in the progress and is not rejected,
you can choose to answer it or not, or perform other features.
When the phone receives an incoming call in the idle state, the screen prompts the incoming call information.
To ignore the call, and initial a new call, pick up the handset, press the Speakerphone key or HEADSET key, press
l
keypad or other line key.
To answer the incoming call, press the corresponding line key, the Answer soft key or the OK key.
l
When the phone receives an incoming call in the call state, the screen does not prompt the incoming call information.
You can perform other features on the current call. You can only answer the incoming call after ending the current call.
<y0000000000xx>.cfg
Call Features
287