Multicast Paging Settings Configuration - Yealink SIP-T2 Series Administrator's Manual

Paging Barge
You can set your phone whether an incoming paging call interrupts an active call.
The Paging Barge defines the lowest priority of the paging group from which the phone can receive a paging call when
there is a voice call (a normal phone call rather than a multicast paging call) in progress. You can specify a priority that
the incoming paging calls with higher or equal priority are automatically answered, and the lower ones are ignored.
If it is disabled, all incoming paging calls will be automatically ignored.
Paging Priority
You can set your phone whether a new incoming paging call interrupts a current paging call.
The Paging Priority feature decides how the phone handles incoming paging calls when there is already a paging call
on the phone. If enabled, the phone will ignore incoming paging calls with lower priorities, otherwise, the phone will
answer incoming paging calls automatically and place the previous paging call on hold. If disabled, the phone will
automatically ignore all incoming paging calls.
DND for Ignoring Paging Call
If you do not want to miss some urgent paging calls when DND is activated. You can use the Ignore DND feature to
define the lowest priority of paging group from which the phone can receive an urgent paging call when DND is activ-
ated. You can specify a priority that the incoming paging calls with higher or equal priority are automatically answered,
and the lower ones are ignored. It is not applicable to CP920 IP phones.
If it is disabled, all the incoming paging calls will be ignored when DND is activated in phone mode.
Topic

Multicast Paging Settings Configuration

Multicast Paging Settings Configuration
The following table lists the parameters you can use to change multicast paging settings.
Parameter multicast.codec
It configures the codec for multicast paging.
Example:
Description
multicast.codec = G722
Note: It is not applicable to T19(P) E2 IP phones.
Permitted
PCMU, PCMA, G729, G722
Values
Default G722
Web UI Features->General Information->Multicast Codec
Parameter multicast.receive_priority.enable
It enables or disables the IP phone to handle the incoming multicast paging calls when there is an active
Description
multicast paging call on the IP phone.
0-Disabled, the IP phone will ignore the incoming multicast paging calls when there is an active multicast
Permitted
paging call on the IP phone.
Values
1-Enabled, the IP phone will receive the incoming multicast paging call with a higher priority and ignore
<y0000000000xx>.cfg
<y0000000000xx>.cfg
Call Features
327