Wi-Fi Configuration - Yealink SIP-T2 Series Administrator's Manual

You can check the Wi-Fi dongle MAC address at the path: Menu->Status->Wi-Fi MAC (phone user interface) or
Status->Status->Network Common->Wi-Fi MAC (web user interface).
Note
To use Wi-Fi feature on T48G/T48S/T46G/T46S/T42S/T41S/T29G/T27G IP phones, make sure the Wi-Fi USB dongle is prop-
erly connected to the USB port on the back of the phone. The Wi-Fi USB dongle should be purchased separately.
Topic

Wi-Fi Configuration

Wi-Fi Configuration
The following table lists the parameters you can use to configure Wi-Fi.
Parameter static.wifi.function.enable
It enables or disables the Wi-Fi feature.
Description
Note: It is only applicable to T54S/T52S/T48S/T48G/T46S/T46G/T42S/T41S/T29G/T27G/CP920 IP phones.
0-Disabled
Permitted
Values
1-Enabled
Default 1
Parameter static.network.redundancy.mode
It configures the network connection mode to be used preferentially.
Description
Note: It is only applicable to T54S/T52S/T48S/T48G/T46S/T46G/T42S/T41S/T29G/T27G/CP920 IP phones.
0-If Wi-Fi mode is activated, the wired network is unavailable; Wi-Fi mode must be deactivated if you
want to use the wired network.
Permitted
Values 1-Use wireless network preferentially.
2-Use wired network preferentially.
Default 0
Parameter static.network.redundancy.failback.timeout
It configures the time to wait (minutes) for the IP phone to switch to the preferred network (configured
by "static.network.redundancy.mode").
Description
Note: It works only if "static.network.redundancy.mode" is set to 1 or 2. It is only applicable to
T54S/T52S/T48S/T48G/T46S/T46G/T42S/T41S/T29G/T27G/CP920 IP phones.
Integer from 0 to 1440
0-The phone will not switch as long as the current network is available.
Permitted
Values
1 to 1440–The phone will keep using the current network for the specified time after the preferentially
used network becomes available. If the preferentially used network is still available after the specified
time, the phone performs a network switch while the phone is not in use.
Default 55
Parameter static.wifi.enable
It activates or deactivates the Wi-Fi mode.
Description
Note: It is only applicable to T54S/T52S/T48S/T48G/T46S/T46G/T42S/T41S/T29G/T27G/CP920 IP phones. It
[1]
[1]
[1]
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
Phone Network
39