Notification Popups Configuration - Yealink SIP-T2 Series Administrator's Manual

Administrator's Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
Topic

Notification Popups Configuration

Notification Popups Configuration
The following table lists the parameters you can use to configure notification popups.
Parameter features.voice_mail_popup.enable
It enables or disables the IP phone to pop up the message when it receives a new voice mail.
If the message disappears, it will not pop up again unless the user receives a new voice mail or the user
Description
re-registers the account that has unread voice mail(s).
Note: It works only if "account.X.display_mwi.enable" is set to 1 (Enabled).
Permitted
0-Disabled
1-Enabled
Values
Default 1
Web UI Features->Notification Popups->Display Voice Mail Popup
Parameter features.voice_mail_alert.enable
It enables or disables the IP phone to pop up the message when receiving the same amount of new voice-
Description
mails.
Permitted
0-Disabled
1-Enabled
Values
Default 0
Parameter features.missed_call_popup.enable
It enables or disables the IP phone to pop up the message when it misses a call.
Description
Note: It works only if "account.X.missed_calllog" is set to 1 (Enabled).
Permitted
0-Disabled
1-Enabled
Values
Default 1
Web UI Features->Notification Popups->Display Missed Call Popup
Parameter features.forward_call_popup.enable
It enables or disables the IP phone to pop up the message when it forwards an incoming call to another
Description
party.
150
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg